perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 5 (click to view)
3. Cleaning
Clean both the inside and outside of the appliance before putting it into use. To do so, use a soft towel, lukewarm water and a non-abrasive detergent. Ensure water does not enter the rear cover grill or the control panel. Afterwards, wipe the appliance with a clean towel and cleanwater, and then wipe it dry. To avoid damage, do not use soap, soda or abrasive cleaners.
4. Positioning the appliance
During the refrigeration process, the appliance gives off heat from the condenser (under the upper part of the rear cover) into the surrounding air. The more ventilated the condenser is, the more effective the refrigeration will be. For maximum performance the appliance must be level at all times when operating. If the appliance is operating in a moving vehicle, the amount of the refrigeration will be slightly less than if the appliance is level in a stationary position.This is caused by the movement of the vehicle impairing the flow of the refrigerant within the unit. It is important that the appliance is not directly exposed to radiated heat (sunlight, radiator, near an oven, etc.).
5. Using the appliance
The cable for 240 Volt mains connection, the 12V connection and the gas inlet are located on the rear cover of the B533 (Figure 2).
5.1. Operating from 240 Volt electrical mains
Before using your refrigerator box, please check whether the mains-voltage at your home or at the camp-site is the same as that specified on the ratingplate. The rating-plate is located on the back of all modells. Your refrigerator is fitted with a regular earthed plug for connection to a regular earthed socket (please use an adaptor when abroad). Now turn the thermostat control (A) to maximum cooling i.e. in a clockwise direction as far as the stop. When a sufficient low temperature has been reached, the thermostat control (A) can be turned back again to obtain the degree of cooling desired. If you wish to switch off the unit or to defreeze it, turn the thermostat control (A) in the anti-clockwise 5
Figure 2.
