This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Exactly as described, the full user-manual (145 pages). Perfect.
Text excerpt from page 16 (click to view)
Operating sequence
1. Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
8a. Setting and starting the programme without DELAY START
Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. Select, if required, the HALF LOAD option.
2. Press the ON-OFF push button
The ON-OFF indicator light will come on.
3. Check that there is rinse aid and salt
The corresponding indicator lights will illuminate if refilling is necessary.
The start of the programme will occur after about 6 seconds from the last pressure of a push button (programme or HALF LOAD push button), in this time it is possible to change programme simply pressing the push button of another programme. Once the programme has started the phase indicator lights will turn off except for the phase under way. It is possible to interrupt the programme by:
q q
4. Load the dishes
Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it. Slide the baskets back into the machine.
opening the door pressing the ON-OFF push button (in this case all the indicator lights turn off)
Close the door again o press the ON-OFF, the programme will start from the point in which it was interrupted.
5. Ensure that the spray arms can rotate freely. 6. Measure out detergent
Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart. Important! If the half load option is selected remember to reduce the quantity of detergent. Close the detergent dispenser lid.
8b. Setting and starting the programme with DELAY START
The setting of the delay start occurs before selecting the programme. Press the DELAY START push button and selected the desired time (3, 6 or 9 hours) until the indicator light corresponding to the chosen hours flashes. Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. The start of the countdown will occur after about 6 seconds from the last pressure of a push button (programme or HALF LOAD push button). The countdown will decrease with step of 3 hours and you are informed of this by the indicator lights of the hours.
16
