Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
The manuel was exactly what I needed and I received it promptly. Thanks
Text excerpt from page 3 (click to view)
Description of the appliance
1. Light switch 2. Motor speed switch 3. Work light 4. Suction grid with grease filter
0 I
1
0
I
2
3
2
Standard accessories included:
q Template for mounting on wall and under cupboard q Screws: q Duct with no return valve q Cover for unused outlet hole
4 3
Fig. 1
G
Function
The hood may be used as follows: - For air exhausting - For air recycling
H
Exhausting
The appliance has two exhaust outlets; D and E (Fig. 2). Important! To use the back hole E, remove air switch F from the top hole. Connect the hood to the smoke exhaust hose by using the connecting ring G with no return valve (bayonet coupling). Insert plug H in the unused exhaust hole (bayonet coupling). Plug H is for closing the unused hole. Attention! In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Please keep to the provisions of official directives regarding the question of fumes discharge.
D E
F
D
E
Fig. 2
Recycling
The air is filtered through a carbon filter and recirculated into the room through the front grid (fig. 3). This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. 28
