Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
Text excerpt from page 5 (click to view)
Special accessories
Active carbon filter
When the hood is used in recirculation mode an active carbon filter should be used. Order by the retailer PNC 942 120 180
Installation
Unpacking
Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it.
Min 60 cm
Min 70 cm
Placement
The hood is to be mounted on the wall or under a wall cupboard. When installed, the hood must be not less than 60 cm. above electric burners or 70 cm. above gas or mixed-fuel burners. (Fig. 4). Fig. 4
H I H I
OPEN
Electrical connection
The hood has a power cord with moulded plug with earth connection to be connected to a wall outlet of 230 V. The power cord length is 1 m.
H
Mounting of hood on wall
l Fix the drilling template to the wall (Fig. 5). l Make 3 � 8 mm holes in the wall. 2 at points H, 1 as desired at points I. l Insert the three � 8 mm expansion plugs into the wall. l Insert 2 5x45 screws at points H but do not tighten them completely. l Open the grid. l Fit the hood into holes H, tighten the 2 screws.
CLOSED
I
H I
I
H
Fig. 5
H I
l From inside the hood, insert the third 5x45 screw into hole I (Fig. 6). 5
