This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 21 (click to view)
Adjustment of minimum level of plate burners To adjust the minimum level: 1) turn the knob to the position of minimum flame; 2) remove the knob (Fig. 35); 3a) in case of conversion from natural gas to LPG, tightly screw the by-pass pin of the cocks; 3b) when converting from LPG to natural gas unscrew about one-fourth turn by-pass pin, until a regular small flame is reached. Reassemble the parts following the same procedure backards. Check that, turning quickly the knob from the maximum position to the minimum one, the flame does not go out.
Replacement of oven burner nozzle To replace the oven nozzle, follow this procedure: a) remove the bottom of the oven; b) c) unscrew screw 1 (fig. 36) and take the oven burner out; with a socket spanner 7 unscrew and remove the nozzle, situated in the bottom of the oven, and replace it with the proper one (see Table 2); reassemble the burner following the same procedure backwards.
FO 0068
Fig. 35
d)
Replacement of grill burner nozzle To replace the grill burner nozzle, act as follows: a) remove the screws, marked with letter "A" in Fig. 37; b) take the grill burner out; c) with a socket spanner n.7, unscrew and remove the nozzle, situated in the oven top, and replace it with the proper one (see Table 2); d) reassemble the burner following the same procedure backwards. Minimum level adjustment of oven burner After setting the oven on maximum temperature with closed door for about 10 minutes, turn the knob of the thermostat on 140, remove the knob and: � in case of conversion from natural gas to LPG, tightly screw the by-pass pin of thermostat (fig. 35); � converting from LPG to natural gas, unscrew the by-pass pin, until a regular small flame is reached. Oven and grill burners don't need any primary air regulation.
