Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
Text excerpt from page 31 (click to view)
THE ELECTRONIC TIMER
Please note that this is a 24 hour clock, for example 2.00 p.m. is shown as 1400. In the following pages we explain how to set the controls. Read through them a few times until you are familiar with the procedure. If the oven is switched off on the wall, or there is a loss of power, the clock will stop and you will not be able to use the ovens. When you first switch the electricity supply on, the timer display will flash. Selector Setting knob Cookpot symbol Bell symbol
TO SET THE TIME OF DAY
Turn the selector knob to 'Manual' then turn to 'Time Setting'. Set the correct time by turning and holding the setting knob clockwise. Adjust the time by turning the setting knob in either direction. Turn the selector knob back to 'Manual'.
TO USE THE COUNTDOWN
Turn the selector knob to â€˜Countdownâ€™. Turn the setting knob clockwise until the display shows the time you want. The bell symbol ( ) will be showing and this will stay lit up during the time. Our diagram shows the timer set to 5 minutes. If you change your mind and want to cancel the time you have set, simply turn the setting knob anticlockwise. Then turn the selector to â€˜Manualâ€™. When you are using the 'Countdown' you can make the clock show the time of day by turning the selector knob to â€˜Manualâ€™. The bell symbol will stay on to remind you that the 'Countdown' is set. At the end of the timed period an alarm will sound and the bell symbol will go out. Switch off the alarm by turning the selector knob to â€˜Time Settingâ€™. Then turn to â€˜Manualâ€™ and the time of day will show in the display.
You can use the 'Countdown' when an automatic sequence has been set, as long as you remember the following point. 1. Turn the selector knob to â€˜Automaticâ€™ as soon as you have entered the timed period into the display.