I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
I was impressed with the quality of service (frequent e-mails to let you know the status of your order), and the speed at which the download became available. The manual was a life saver and was not easy to track down. Thank you for such an excellent service.
GOOD SERVICE MANUAL GOT ALL THE INFO. THAT I NEEDED..
Text excerpt from page 9 (click to view)
In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be open.
9. To cancel a programme in progress
If the door has not been closed and therefore the programme has not started, it is possible to change the selection made simply pressing the push button of another programme. A programme underway can be cancelled, by opening the door and pressing for about 1 second the programme push button of the programme underway. The corresponding indicator light will turn off. A new programme can now be selected.
1. Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
2. Press the On/Off push button
The On/Off indicator light comes on.
10. At the end of the washing programme
The dishwasher will automatically stop and an intermittent audible signal will be heard when the programme has ended. The indicator light of the programme just ended turns off while the "end of cycle" indicator light flashes. The On/Off indicator light remains illuminated until the On/Off push button is depressed. Open the door and switch off the dishwasher by pressing the On/Off push button. Wait a few minutes before removing the dishes; in this way they will be cooler and drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Important! In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
3. Check that there is rinse aid and salt
4. Load the dishes
Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it. Slide the baskets back into the machine.
5. Ensure that the spray arms can rotate freely
6. Measure out detergent
Add the required amount of detergent into the dispenser. Close the detergent dispenser lid.
7. Set the programme
Press the programme push button which corresponds to the washing programme you wish to select, the corresponding indicator light starts flashing.
8. Start the programme
Close the door, the programme will start automatically. An audible signal advises you that the programme has started and the indicator light which corresponds to the programme underway is now permanently on.