Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
What can i say but i would have been lost without your support.
Thank You!
Text excerpt from page 31 (click to view)
152982 382 en
14-06-2001
9:40
Pagina 31
Installation
Adjusting the worktop
You can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units. Simply unscrew the two rear retaining screws, move the top to the required position and then retighten the screws.
IN26
Fitting under a counter (kitchen worktop or sink)
By removing the machine�s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. Proceed as follows: - Remove the machine�s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop. - Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
600
570 -
820
600
IN05
Levelling
Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.
31
