Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
Text excerpt from page 28 (click to view)
CHOICE OF ELECTRICAL CONNECTION
The appliance should be operated using at least 2 6mm twin core and earth PVC insulated multicore cable. Please choose from the most appropriate after reading the different methods. By connecting the appliance to a cooker point having a double pole isolating switch with at least 3mm contact separation in all poles and protected with a fuse or miniature circuit breaker at your mains fuse box. If you wish to connect an oven and a hob to a cooker point you can, by connecting the oven and hob separately to the cooker point. Oven and hob units should be separately connected to a cooker point. See Fig. 4. Fit an Earth Leakage Circuit Breaker to your house wiring. Wire your appliance to the latest IEE regulations. Fig. 4
NOTE: It is good practice to :
PREPARING CABINET FOR FITTING OF OVEN
Â· Â· Â· Â· Â· Â· Â· Â·
Make sure the space between the cabinets is the correct size for the appliance to be fitted (Ref. Fig. 5 & 6). The plinth board spanning the space into which the appliance is to be installed should be removed. If the size is between adjacent cabinets is 605610mm, then the cabinets should be modified so that the recommended dimension of at least 600605mm is maintained. The cabinets must be stable and level by firmly securing it to the wall or floor. If necessary, make arrangements to ensure the shelf upon which the oven will rest is level. The adjacent cabinets must be stable and level by firmly securing to the wall or floor. If necessary, make arrangements to ensure the work surface below which the oven will rest is level. Drill two pilot screw holes into the sides of the adjacent cabinets, in the positions indicated by Fig. 5. Fit the appliance mounting brackets using the two holes indicated in Fig. 7 to the adjacent cabinets (Ref. Fig. 5 & 6). Check that the mounting brackets are level. They can be adjusted if necessary by using the extra holes at the ends of the brackets. Once the brackets are level, drill a pilot hole through the central hole in the bracket and fit the remaining screw.