Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
Text excerpt from page 14 (click to view)
MAINTENANCE AND CLEANING
Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply.
The dangers of freezing
If the machine is exposed to temperatures below 0Â°C, certain precautions should be taken.
The water we normally use contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits.
Turn off the water taps. Select a wash programme and run for a few seconds. Unscrew the inlet hoses. Unhook the drain hose from the rear support and position the end in a bowl. Run the draining programme for a few seconds. When you intend to start the machine up again, make sure that the room temperature is above 0Â°C.
After each wash
Leave the door open for a while. This helps to prevent mould and stagnant smells forming inside the appliance. Keeping the door open after a wash will also help to preserve the door seal.
Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly.
Cleaning the dispenser drawer
From time to time the washing powder and additive dispenser drawer should be cleaned. Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder.
Cleaning the drawer recess
Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme for a few minutes without any clothes in the drum.