ZOOM GFX-3
Owner's Manual

Changing the Sound of a Patch

DRIVE module

REV/DLY(Reverb/Delay) module MOD(Modulation) module EQ(Equalizer) module

COMP/ISO (Compressor/Isolator) module ZNR/[TOTAL] module

The effect type of the MOD and REV/DLY modules is set with the [MOD] selector and [REV/DLY] selector respectively.
[MOD] Selector [REV/DLY] Selector

The parameters that are assigned to the parameter keys for each module are printed on the panel. When the EQ module is selected, the parameter keys correspond to the following parameters.
Parameters
PRESENCE TREBLE

4.

Use the module keys to select the module to edit.
EQ modul

MIDDLE BASS

The module keys serve for selecting an effect module to work with. The assignment of keys to effect modules is shown above. The keys for modules that are ON in a given patch are lit. When you press a key to select the module, the light �ashes. (If you select a module that is currently off, the key �ashes more slowly.)

NOTE
When you use the selector to switch the effect type, the parameter type also changes. Select the effect type �rst, and then select the parameter.

7.

Use the [VALUE] dial to change the setting.

5.

To switch the module between ON and OFF, press the module key once more. Select the parameter to edit with the parameter keys.

The [VALUE] dial controls the setting value of the currently selected parameter. The current setting value is shown on the display.

6.

8.

Repeat steps 3 - 7 to edit other modules and parameters.

The parameter keys serve for choosing a parameter within the currently selected module. Each push of the key brings up the next parameter, and the setting value of that parameter is shown on the display.

NOTE

To keep the patch, be sure to perform the steps for storing it (� p. 14). Otherwise all changes will be lost when you switch to another patch.

ZOOM GFX-3

13