Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Text excerpt from page 22 (click to view)
Installation
Power supply
The dishwasher is supplied with a lead and electrical plug for connection to a 230 V, 13 A earthed wall socket. Before any work is carried out on the dishwasher, it must be isolated from the electric mains supply, for example by removing the plug from the wall socket. Permanent electrical installation must be carried out by an authorised electrician or competent person.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure not be observed. The appliance should not be connected to the electrical supply by means of an extension cable. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug �tted. Remove the fuse from the cut off plug. Important: The plug must still be accessible after the appliance has been installed.
GREEN & YELLOW 13 AMP FUSE
Important
The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Blue Brown - Earth - Neutral
BLUE 13 AMP BROWN CORD CLAMP
- Live
If you �t your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol or coloured green and yellow. Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black. Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red. The plug moulded onto the lead incorporates a fuse. For replacement, use a 13 amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely.