My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
The owners manual is very good. all my how to questions were answered in detail.
Text excerpt from page 27 (click to view)
3
Special spanner A and sealing caps B (2 units) and C (1 unit) come with the appliance. 3. Use special spanner A to remove screw D and the compression spring. 4. Use sealing cap C to cap the hole. 5. Use special spanner A to remove the two screws E. 6. Use special spanner A to remove the four screws F. 7. Remove transit bar G. 8. Screw in the four screws F again. 9. Use sealing caps B to cap the two large holes. Important: Press all sealing caps B (2 items) and C (1 item) in firmly so that they snap into the rear wall.
Where to install
Important! The washing machine must not be operated in a room where there is a danger of frost. There is a risk of frost damage or adverse effect on the perfomance of the machine. Frost damage is not covered under the warranty. � The surface on which the appliance is to be installed must be firm and level. Do not install the appliance on carpeted floors or soft floor coverings. � The surface on which the appliance is to be installed must be clean and dry and free from grease, so that the appliance does not slide. � If the location in which the appliance is to be installed is fitted with small-format tiles, put a rubber mat (available in the shops) under the appliance. If the appliance is to stand on a floor which moves, e.g. a suspended wooden floor: Place the appliance in an area as close as possible to a corner of the room. 1. Screw a water-resistant wooden board (at least 15 mm thick) onto at least 2 of the floor joists.