RCA RP3503
Owner's Manual

RP3503 EN (23_10_06)

23/10/06

10:08 AM

Page 1

Important Battery Information
user manual
Guide de l�utilisateur
� Batteries may leak electrolyte if inserted incorrectly, if disposed of in fire, or if an attempt is made to charge a battery not intended to be recharged. � Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury. � Dispose of batteries, according to federal, state, and local regulations.

Automatic Stop
When your recorder is operating in PLAY or RECORD mode and the end of the tape is reached, your unit will automatically shut itself off and return the buttons to the OFF position.

Tape Care
� Don�t expose tapes to sunlight or store in hot places. High temperatures may warp the shell or damage the tape itself. � Keep cassettes in their boxes when not in use. � Cassette tapes can be erased by magnetic fields produced by magnets, electric motors, electrical transformers, and other devices. Keep tapes away from magnets and magnetic fields. QUIT SLACKING A little bit of slack in your tapes can cause scratches on the tape, or worse yet, the tape could break. If you notice some slack in the tape, use a pencil to tighten it up before you insert it.

Stand-up Microphone Recording
To record with stand-up microphone, plug the microphone into the MICROPHONE jack and follow the built-in microphone recording instructions. When the stand-up microphone is used, the built-in microphone is automatically disconnected.

Before you begin
Unpacking Your Unit
You should have the following: � one main unit � one AC power converter � one stand-up microphone � one user�s guide

A

Tape Erase
To erase a tape simply record over the unwanted recording.

Warranty
LIMITED WARRANY (US) What your warranty covers: � Defects in materials or workmanship. For how long after your purchase: � One year from date of purchase. The warranty period for rental units begins with the firstthe rental 45 days from date of shipment to rental or firm, whichever comes first. What we will do: � Provide you with a new, or at our option, a refurbished unit. The exchange unit is under warranty for the remainder of the original product�s warranty period. � Proof of purchase in the form of a bill of sale or receipted invoice which is evidence that the product is within the warranty period must be presented to obtain warranty service. For rental firms, proof of first rental is also required. How to make a warranty claim: � Properly pack your unit. Include any cables, etc., which were originally provided with the product. We recommend using the original carton and packing materials. � Include evidence of purchase date such as the bill of sale. Also print your name and address and a description of the defect. Send via standard UPS or its equivalent to: Thomson Inc. Product Exchange Center 11721 B Alameda Avenue Socorro, Texas 79927 � Insure your shipment for of loss or damage. Thomson accepts no liability in case of damage or loss en route to Thomson. � Pay any charges billed to you by the Exchange Center for service not covered by the warranty. � A new or refurbished unit will be shipped to you freight prepaid. What your warranty does not cover: � Customer instruction. (Your Owner�s Manual provides information regarding operating Instructions and user controls. For additional information, ask your dealer.) � Installation and setup service adjustments. � Batteries. � Damage from misuse or neglect. � Products which have been modified or incorporated into other products. � Products purchased or serviced outside the USA. � Acts of nature, such as but not limited to lightning damage. Product Registration: � Please complete and mail the Product registration Card packed with your unit. It will make it easier to contact you should it ever be necessary. The return of the card is not required for warranty coverage. Limitation of Warranty: � THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION GIVEN BY THOMSON INC., ITS AGENTS OR EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY. � REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER. THOMSON INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF INDIANA. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE. How state law relates to this warranty: � Some states do not allow the exclusion nor limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. � rights, and you also you specific legal This warranty gives may have other rights that vary from state to state. If you purchased your product outside the USA: � This warranty does not apply. Contact your dealer for warranty information. LIMITED WARRANY (CANADA) Thomson multimedia Ltd. warrants to the purchaser or gift recipient that if any manufacturing defect becomes apparent in this product within 1 year from the original date of purchase, it will be replaced free of charge, including return transportation. This warranty does not include damage to the product resulting from accidents, misuse or leaking batteries. Should your product not perform properly during the warranty period, either: 1. Return it to the selling dealer with proof of purchase for replacement, OR 2. Remove the batteries (where applicable), and pack product complete with accessories in the original carton (or equivalent). � Mail prepaid (with proof of purchase) and insured to: Thomson multimedia Ltd. 6200 Edwards Blvd., Mississauga, Ontario, L5T 2V7 Canada The provisions of this written warranty are in addition to and not a modification of or subtraction from the statutory warranties and other rights and remedies contained in any applicable legislation, and to the extent that any such provisions purport to disclaim, exclude or limit any such statutory warranties and other rights and remedies, such provisions shall be deemed to be amended to the extent necessary to comply therewith. If you are unable to find a qualified servicer for out of warranty service, you may write to: Thomson Inc. P.O. Box 0944 Indianapolis, Indiana, U.S.A., 46206-0944 Attach your sales receipt to this booklet for future reference. This information is required if service is needed during the warranty period. PURCHASE DATE NAME OF STORE

Rewind
To run the tape back to the beginning of your recording, press REWIND. Then press STOP after you have rewound to the desired point on the tape.

Powering the Recorder
Battery Installation
1 To remove the battery compartment door (located on the cabinet bottom) press the snap tab and lift the door off the cabinet back. 2 Insert 4 "AA" - size batteries (not included) into the battery compartment. Be sure the (+) or cap end of each battery is installed as shown on the battery diagram. 3. Replace the battery door.

Fast Forward (F-fwd)
Press F-FWD to skip over portions of the tape quickly. Press STOP after you have advanced to the desired point on the tape.

Pause Control
Your recorder is equipped with a PAUSE control which will stop PLAY & RECORD operation. Press PAUSE to stop PLAY or RECORD operation. Press again to release PAUSE for continued operation.

Tape Counter and Reset Button
The reset counter is used to quickly determine the approximate location of different recording selections. 1. Rewind to the beginning of the tape. 2. Press the Reset Counter once to read "000". After each selection is played or recorded, make a note of the numbers in the readout window. This will serve as a reference for the start of the next selection or recording. NOTE: If the recorder begins to sound distorted, or if the tape reels turn very slowly or not at all, be sure to check with a new set of batteries or another cassette before seeking service. IMPORTANT: Be sure to remove the batteries when storing the set for more than a few weeks at a time. Leaky batteries can badly damage the recorder. When discarding batteries, be sure to dispose of them in the proper manner, according to provincial and 3. To locate a selection previously noted, press either F-FWD or REWIND. When the counter indicates the selection number you desire, press STOP/EJECT. NOTE: The Reset Counter will not indicate actual distance in units of measure; it determines only the relative location of each selection.

Care & Maintenance
Prevent Accidental Erasure
Whenever you make a recording, any previous recording on the tape is automatically erased. When you have a recording you want to keep permanently, snap out the rear left tab of the side you want to save as shown in the illustration below.
A

RP3503
It is important to read this instruction book prior to using your new product for the first time. Nous vous recommandons de lire ce manuel d�instructions avant d�utiliser votre nouveau produit pour la première fois.

local regulations. Always push STOP before storing. This will relieve pressure on certain parts in the recorder that might deform after long periods of time.

AC Power Converter
The AC Power Converter plugs into the 6-V DC PWR JACK on the recorder (which automatically disconnects the batteries), and plugs into 120 -volt AC household power.

Safety Information
For Your Records
In the event that service should be required, you may need both the model number and the serial number. In the space below, record the date and place of purchase. Date of Purchase: Place of Purchase:

IMPORTANT: The AC Power Converter coming with this unit is intended to be correctly orientated in a vertical or floor mount position.

Car Adapter (Optional)
Your recorder may be operated from the cigarette lighter socket in a car. The optional Car Adapter plugs into the 6-V DC PWR JACK on the recorder, which automatically disconnects the batteries.

When a cassette with the tab snapped out is inserted into the tape unit, accidental erasure is prevented by a lever in the mechanism that keeps the RECORD button from depressing. Cellophane tape can be place over the opening if you decide later to record over the original recording. Similarly, you can record over purchased pre-recorded cassettes.

Service Information
This product should be serviced only by those specially trained in appropriate servicing techniques. For instructions on how to obtain service, refer to the warranty included in this Guide. Main plug is used as the disconnect device, it

Have a Blast - Just Not in Your Eardrums Make sure you turn down the volume on the unit before you put on headphones. Increase the volume to the desired level only after headphones are in place.

To Insert or Remove Cassette
1. Press STOP/EJECT if any of the buttons are depressed. 2. Press STOP/EJECT to open CASSETTE DOOR. 3 Insert a cassette tape with a full reel at its left and open edge facing towards you, then push on the deck door to close. Unload a cassette tape by following the above steps 1 and 2, take out the tape, push on the deck door to close. PLEASE NOTE: Your unit is equipped with a cassette sensing mechanism. This mechanism prevents the RECORD button from being depressed when a cassette is not in the unit.

Headphone (Optional)
You can plug a set of headphones to your set. With the headphone plugged in, the speaker is automatically silenced for private listening. Your set is also equipped with EARPHONE MONITOR capability when recording direct from other sound sources such as other tape recorders, radios or phonographs. You can listen to what's being recorded by plugging in a set of headphones and an adapter.

shall remain operable and should not be obstructed during intended used. To be completely disconnected the apparatus from supply mains, the main plug of the apparatus shall be disconnected from the mains socket outlet completely. The descriptions and characteristics given in this document are given as a general indication and not as a guarantee. In order to provide the highest quality product possible, we reserve the right to make any improvement or modification without prior notice. The English version serves as the final reference on all products and operational details should any discrepancies arise in other languages.

Reset Counter

Remote On/Off Jack (2.5mm)
The use of a remote on/off unit enables you to temporarily stop recording, when using a remote microphone, without resetting the buttons. Such remote control units are usually available from local audio supply houses. When selecting a remote control on/off unit, be sure it is equipped with a 2.5mm plug.

NOTE: Some special formula tapes (chromium dioxide and metal particle tapes) cannot be properly recorded on this product. These tapes can, however be used for playback.

Precautions
� Never open the cabinet under any circumstances. Never operate this product with the cabinet removed. Any repairs or internal adjustments should be made only by a trained service technician. � Do not touch the player with wet hands. If any liquid enters the player cabinet, take the player to a trained service technician for inspection. NOTE: Only use the adapter that came with this unit. Using other adapters could seriously damage the unit. Do not attempt to bypass this safety feature.
RISK OF ELECTRIC SHOCK DO NOT OPEN
THE LIGHTNING FLASH AND ARROWHEAD WITHIN THE TRIANGLE IS A WA R N I N G S I G N ALERTING YOU OF "DANGEROUS VOLTAGE" INSIDE THE PRODUCT. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, D O N OT R E M OV E C OV E R ( O R BAC K ) . N O U S E R S E RV I C E A B L E PA RT S I N S I D E . R E F E R S E RV I C I N G T O Q UA L I F I E D S E RV I C E PERSONNEL. THE EXCLAMATION POINT WITHIN THE TRIANGLE IS A WARNING SIGN ALERTING YOU OF I M P O R TA N T INSTRUCTIONS A C C O M PA N Y I N G T H E P R O D U C T.

Tape Play
To listen to your recorded tape cassettes: 1. Insert cassette as explained above. 2. Rewind tape to the starting point if necessary. ( See REWIND operation.) 3. Press PLAY. 4. Adjust VOLUME control.

Cleaning the Heads
Iron oxide particles from the magnetic tape can build up on the parts that come in contact with the tape. These deposits can cause incomplete erasure, muffled playback sound, and might prevent automatic stop. To clean a cassette tape, open the compartment door, push the PLAY button and gently clean the heads, capstan, and pinch wheel with a head cleaner.

Built-in Microphone Recording
1. Insert cassette as previously described. Press RECORD (the PLAY button is depressed with it). You are now recording. If the RECORD button does not depress, see "PREVENT ACCIDENTAL ERASURE". 2. Talk normally into the BUILT-IN CONDENSER MICROPHONE. To obtain optimum recording quality, place the recorder with the microphone freely exposed and as close as convenient to the sound source. NOTE: The automatic level control (ALC) will set the record level for optimum recordings, regardless of volume setting.

CAUTION

SEE MARKING ON BOTTOM / BACK OF PRODUCT

WARNING: TO PREVENT FIRE OR ELECTRICAL

Thomson Inc. P.O. Box 1976 Indianapolis, IN 46206-1976 © 2006 Thomson Inc. Trademark(s) ® Registered Marca(s) ® Registrada(s) Marque(s) ® Deposée(s) www.rca.com Printed In China / Impreso en China 56418020 (EN/F)

Always unplug the power cord before cleaning, and allow 30 minutes drying time when using a liquid cleaner. Clean heads after every 25 hours of use. � Demagnetize the head occasionally with a head demagnetizing cassette (available from many audio equipment stores). � Never use any metal objects on or near the tape heads. Do not allow any cleaning material to fall into the tape assembly.

SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

A

A

Using the Recorder

A

60