Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Text excerpt from page 6 (click to view)
How to Mow
1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. 2. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and this may also result in poor collection. Do Not Overload Your Mower: Mowing long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed drops you may overload your lawnmower which may cause damage. When mowing in long thick grass a first cut with the cutting height set higher will help reduce the load. See Cutting Height Adjustment.
Removing and Fitting the Blade and Fan (Q)
Always handle the blade with care - sharp edges could cause injury. USE GLOVES. Removing the Blade and Fan 1. To remove the blade bolt, hold the fan firmly and, with the spanner provided, loosen the blade bolt by turning it anti-clockwise. 2. Remove the blade bolt, blade and fan from the pulley. 3. Inspect for damage and clean as necessary. Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. If the blade is cracked or damaged replace it with a new one. Fitting the Blade and Fan 1. Ensure the fan is located correctly. 2. Fit the blade to the fan. 3 Re-assemble blade bolt through blade and fan. 4. Hold the fan and tighten blade bolt firmly with the spanner provided. Do not over tighten.
Q
fan
blade bolt
blade
pulley
Easi-Reel Cable Winder (Roller Compact 4000 only) R1
Storing your cable in the Easi-Reel cable winder 1. Insert the femaleconnector into the top of the cable winder (R1) 2. Place the cable under the cable guide (R2) 3. Turn the cable winder (R3) until all of the cable is wound in.(R4) Warning:- When cable is fully wound, lid becomes heavy. Unwinding the cable before re-use 1. Pull the cable by the plug and unwind the cable fully. � Ensure that the cable is released from the cable guide (R2) before using your machine.
