|
|
|
Who's Online
There currently are 5518 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great service. Manual is as advertised and delivered when promised.
;
Perfect quality, highly appreciated service !!!
Fast delivery of the download info, no issues at all. Recommended E-manual shop !!!
;
hi owners manual- crew,
i am very satisfied about the trade with you.
if i need some other manuals, i will contact you again.
thanks
frank kappler
;
Full Panasonic service Manual, as described, no problems
;
This place is amazing. Got our manual in a few hours. Print quality is excellent. Even the manufacturer didn't have this manual. The price was excellent. How many more stars can I give them? More than satisfied.
The furniture door
The door on this appliance is designed for the overlay of a panel having the following dimensions: Width Height Thickness Weight 596 mm 604 mm max 20 mm max 2 - 7.5 kg max
The panel height should be no more than indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth. The height of the panel depends on the height of adjacent kitchen units (see "Kitchen plinth adjustment"). Furtermore, it is possible to fine up the control panel to correspond with the height of the drawers of the adjacent pieces of furniture, thus perfectly co-ordinating with the style of the rest of the unit furniture in your kitchen. Add one or more of the fillets provided until you reach the desired height. Secure the fillets as shown in the picture, by means of two screws 4 x 40 provided therewith.
A A
II04
Prepare the panel as follows:
- Measure the distance (B) between the part below the control panel (or fillets) and the reference notch (X) on the door. - Measure the same distance (B) on the wooden panel starting from the upper edge. At this distance position the supporting cross-bar provided, in correspondence with the reference (Z). Keep the same distance between the centre of the support�s fastening holes and the lateral edges of the wooden panel. - On the panel sign the seats for the four fastening screws. Drill the panel with a � 2 x 12 bit and fix the supporting cross-bar onto the wooden panel with the 3.5 x 16 screws provided. - Mount the decor panel by inserting the two pivots of the cross-bar into the slotted holes of the door. Lift the decor panel until the perfect alignment with the facia panel is obtained. Once the correct position has been found, open the door and fasten the decor panel on the lower section by means of the two 4 x 40 screws provided, using the holes through the inner door.
II22
X 1
=
550
B Z
B
=
2
II10
24
PFI12/1GB
|
|
|
> |
|
