Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
The only reason I gave this less than 4 stars, is because it shouldn't take 24 hrs to have the download available. I was surprised to find that I had to wait until the next day to be able to download the manual that I paid for.
The manual itself is the correct manual.
Text excerpt from page 28 (click to view)
The furniture door
The door on this appliance is designed for the overlay or a panel having the following dimensions: Width: Height: Thickness: Weight: 596 mm 604 mm max 20 mm max 2 - 7.5 kg max
The panel height should be no more than indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth. Furthermore, it is possible to line up the control panel to correspond with the height of the drawers of the adjacent pieces of furniture, thus perfectly co-ordinating with style of the rest of the unit furniture in your kitchen. Add one or more of the fillets provided until you reach the desired height. Secure the fillets as shown in the picture, by means of two screws 4 x 40 provided therewith.
A A
II04
Prepare the panel as follows:
Measure the distance (B) between the part below the control panel (or fillets) and the reference notch (X) on the door. Measure the same distance (B) on the wooden panel starting from the upper edge. At this distance position the supporting cross-bar provided, in correspondence with the reference (Z). Keep the same distance between the centre of the support�s fastening holes and the lateral edges of the wooden panel. On the panel sign the seats for the four fastening screws. Drill the panel with a � 2 x 12 bit and fix the supporting cross-bar onto the wooden panel with the 3.5 x 16 screws provided. Mount the decor panel by inserting the two pivots of the cross-bar into the slotted holes of the door. Lift the decor panel until the perfect alignment with the facia panel is obtained. Once the correct position has been found, open the door and fasten the decor panel on the lower section by means of the two 4 x 40 screws provided, using the holes through the inner door.
=
