2 - Replacement Open the pull-out visor and push the lateral knobs of the filter towards the centre while pulling downwards (fig. 10). Refit the filter with the handle on the visible part of the hood.

3.2 - Synthetic fibre filter
1 - This type of filter is printed with red dots. When the filter becomes saturated the red colour of the dots will spread over the whole surface of the filter. At this point the filter has to be replaced. The saturated filter cannot be cleaned or regenerated. 2 - Replacement a - Open the metal grille pushing the knobs towards the centre while pulling downwards (fig. 11). b - Remove the wire clips and replace the synthetic fibre filter (fig. 12). c - Close the metal grille. ATTENTION - There could be a possible fire hazard if the filters are not replaced according to these instructions.

3.3 - Lighting
a - Two 40W lamps ensure the worktop lighting. These lamps can be reached by removing the glass visor (fig. 13). b - Should the two lamps fail to work, open the metal grille and ensure they are correctly screwed into the holder. c - When changing the lamp, an identical replacement must be fitted to ensure the safe working of the cooker hood.

3.4 - Cleaning
When cleaning the hood: - Never use a wet cloth or sponge, or running water; - Never use thinners or products containing alcohol, as they might damage the paintwork; - Never use abrasive cleaning materials, in particular when cleaning stainless steel surfaces. It is recommended to use a damp cloth and mild liquid household cleaner.