This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Text excerpt from page 18 (click to view)
Building the appliance in
¥ ¥ Fit the appliance into the recess. Fix it to the wall with the appropriate bracket.
Â¥
The top of the appliance must be kept clear to allow correct air circulation. If a wall unit is fitted above the appliance, there must be a gap of 50 mm between this unit and the wall and it must be at least 50 mm below the ceiling.
50 50
25
Fitting the plinth
Alignment height of 820 mm
170 220
820 870
Â¥
If using a 140 to 170 mm plinth, make a cut-out as shown.
900
140 30 190 100
Â¥
If using a plinth higher than 100 mm but less than 140 mm, cut the height compensation strip supplied with the appliance to the required depth and fit it between the plinth and the ventilation grille, pressing it into position below this grille.