I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 29 (click to view)
This dishwasher is designed to be fitted under a kitchen counter or worksurface. It is essential that the recess dimensions indicated in the diagram are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm). A distance of 2 mm should be allowed between the top of the dishwasher and the counter top.
575 x ma
Adjusting the height of the appliance
To adjust the height proceed as follows: 1. Loosen or tighten the two front feet. 2. The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right. A pad is supplied for the rear foot to make sliding the appliance in and out of the recess easier. To fit the pad, press it onto the rear foot. If required, the dimensions of this pads can be reduced by breaking it where marked.
0 555 ax m
Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers, either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.