|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Product was very good. Received quickly and complete
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Troubleshooting�s First Line of Defense: Factory-Default Settings Incorrect settings on the receiver and/or transmitter can make the wireless system�s operation seem poor, or even �dead.� To eliminate the possibility that incorrect function settings are the source of problems, restore both the receiver and the transmitter to their factory-default settings. RECEIVER � To return all receiver functions to their original factory-default settings: 1. First, turn the receiver off. 2. Hold in the Mode/Set button while pressing the Power switch to turn the receiver back on. The LCD will briefly show �RESET�, followed by �WAIT� (release the Mode/Set button), before commencing normal-mode operation with all factory-default settings restored. (3.) (If the default frequency is not useable in your area, set both the receiver and the transmitter to the same suitable frequency.) TRANSMITTER � To return all transmitter functions to their factory-default settings: 1. Press the Set button once to move to Menu mode. 2. Press the Up arrow twice to move to �PRESET� in the LCD window. 3. Press the Set button once and �LOAD� will appear in the LCD. 4. Press and hold the Set button until �DEF� appears in the LCD. 5. Press and hold the Set button until �LOADED� appears briefly in the LCD. The window will then revert to �PRESET�. 6. Press the Down arrow once to move to �QUIT�. 7. Press the Set button once to exit the Menu mode and return to normal operation, with all factory-default settings restored.
(8.) (If the default frequency is not useable in your area, set both the receiver and the transmitter to the same suitable frequency.)
�Alert� Conditions The red Alert indicator on the receiver signals the user regarding a number of operating conditions. Transmitter conditions: No RF When no RF signal is received from transmitter. Weak RF When only one or two �RF� signal-strength bars are on. Transmitter Muted When the transmitter is in the Mute* mode. Transmitter Audio Too High When audio modulation level from the transmitter is close to the clipping point (AF +3/+6 bars). Batteries Weak When only one bar of the Battery* �fuel gauge� is on.
Receiver conditions: Edit Mode When the receiver is in the Function Edit mode.
* These functions use digital data supplied from the transmitter. It can take up to several seconds for the receiver display to be �updated� with the latest mute/unmute and battery status information. This is normal operation for both the Alert light and the �BATT� indication.
17
|
|
|
> |
|
