|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
just what i was seeking .had a password issue but the review allowed me to circumvent and download was great
;
Great manual, great price. Has a few of the basic operating instructions that most service manuals leave out. Complete instructions for disassembling board by board, safety precautions, schematics, complete parts list.
;
I am very pleased with the service manual for my RT-909. This was an easy purchase and great procuct, and much cheaper than other venues i had looked at. This web site is now listed in my favorites list. KEEP UP THE GOOD WORK. THANKS. J. BROWN
;
A very well written and easy to understand manual.
;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
Powered Subwoofer
BASS20
IMPORTANT SERVICE NOTE:
Amplifier assemblies with serial numbers less than 11757 should be modified for safe operation. Examine amplifier as follows (serial #11756 or lower) to determine if a factory modification has taken place: 1. 2. 3. 4. 5. Unplug and remove amp assembly; (12) #8 x 3/4" screws. Lift and examine the main (large) amp board, solder (green) side of the board. Look for the presence of two large resistors (1k, 3 Watt or 470 ohm, 1Watt) directly underneath the two large filter caps on the opposite side of the board. If these resistors are present, the unit has been modified. If they are missing, the unit should be modified before future use, regardless of what the initial service concern was. To continue without modification may result in a hazardous condition.
MODIFICATION:
1. 2. 3. 4. 5. 6. 7. 8. 9. Cut tie wraps to bundled wire assemblies for easier access. Circuit board does not have to be removed from heatsink. R36: See drawing: cut trace connecting Q4 collector and main C1 (+) pad. Create solderable surface on PCB, (on Q4 side of cut) by scraping the green mask from board with Exacto knife or similar tool. Attach R36, 470W 1W resistor (JBL #RS2180) to new surface and cathode side of CR1. Resistor should "stand off" from PCB; secure with RTV or epoxy if desired. R41: See drawing; cut trace connecting Q1 collector and main C2 (-) pad. Create solderable surface on PCB, (just above R49) by scaping the green mask from the board with Exacto knife or similar tool. Attach R41, 470W 1W resistor (JBL #RS2180) to new surface and C1 (-) pad. Resistor should "stand off" from PCB; secure with RTV or epoxy if desired. Retie cables with tie wraps. Cut and insert two in-line fuse holders (JBL #155020A) with 4A fuses (JBL #312004); one in each positive wire leading to woofer terminal, close to the amplifier assembly.
10. Replace amp assembly in cabinet.
4
|
|
|
> |
|
