|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks for offering this item at such a good price. Proved handy in identifying the part I was looking for my set.
Thanks again.
;
This is the original manufacturers service manual, with detailed info on the circit boards, explosion drawings of all parts in assembly order, and tuning instructions. The only thing missing is the information on the dimensions of the various drive belts. mail me if you need them. gcrossman_at_aol.com
;
Ordered service manuel for a hard to find plasma tv - your company made it easy to find and purchase - I will use you again
Thanks for your help
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
Power Amplifier APPLICATIONS � BPx MODELS
To the right are several application diagrams to help plan your subwoofer system installation. Figures 1 through 3 show how to configure the JBL Power Series subwoofer amplifiers (models BPx500.1, BPx1100.1 and BPx2200.1) for 2-channel, bridged-mono and parallel-mono operation �Setting the utput Mode� on page 6). O NOTE: For simplicity, Figures 1 through 3 do not show power, remote and input connections. NOTE: If the nominal impedance of your speaker system is close to 2 ohms, be prepared to try both bridged and parallel configurations to determine which performs better.
Set OUTPUT MODE to 2CH/BR
(on input panel)
2 CHANNEL BRIDGED
BPX500.1
CH 1
CH 2
PARALLEL
2CH/BR
BPx Amplifier
(partial rear panel)
PARALLEL*
NEON
OUTPUT MODE
SPEAKER OUTPUTS
*SEE MANUAL FOR PARALLEL CONNECTION
X-OVER
FREQ
Figure 1. The JBL Power Series subwoofer amplifier is set to 2-channel mode to drive a pair of subwoofers.
32Hz 320Hz
12dB 24dB SLOPE
Subwoofer
Subwoofer
Set OUTPUT MODE to 2CH/BR
(on input panel)
PARALLEL 2CH/BR
2 CHANNEL BRIDGED
CH 1
CH 2
BPx Amplifier
(partial rear panel)
PARALLEL*
NEON
OUTPUT MODE
SPEAKER OUTPUTS
*SEE MANUAL FOR PARALLEL CONNECTION
Figure 2. The JBL Power Series subwoofer amplifier is set to bridged (mono) mode to drive a single subwoofer. Use this mode only when the nominal impedance of the speaker system is 2 ohms or greater.
X-OVER
FREQ
32Hz 320Hz
12dB 24dB SLOPE
Subwoofer (2 ohms or greater)
Set OUTPUT MODE to PARALLEL
(on input panel)
PARALLEL 2CH/BR
2 CHANNEL BRIDGED
CH 1
CH 2
BPx Amplifier
(partial rear panel)
jumper
PARALLEL*
NEON
OUTPUT MODE
SPEAKER OUTPUTS
*SEE MANUAL FOR PARALLEL CONNECTION
Figure 3. The JBL Power Series subwoofer amplifier is set to parallel mode to drive a single subwoofer. Use this mode only when the nominal impedance of the speaker system is less than 2 ohms. NOTE: A jumper is added between the + terminals.
X-OVER
FREQ
32Hz 320Hz
12dB 24dB SLOPE
Subwoofer (less than 2 ohms)
4
|
|
|
> |
|
