|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Ordered service manuel for a hard to find plasma tv - your company made it easy to find and purchase - I will use you again
Thanks for your help
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
;
When I purchased this manual I had my doubts regarding the quality as the price was so reasonable as compared to other outlets.
The manual itself is of high standard the print is very clear as are the diagrams. Obviously with the diagrams one has to zoom in otherwise it is to small to be able to read.
Overall I am very pleased with the company who delivered as they said and with the manual they supplied.
I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
I was at first dubious about payiong for downloaded manuals but having done so, I was extremely impressed with quality of the two manual I ordered, well worth the small price I paid.
I would highly recommend these to my friends.
PAGE 3 OF 3 NOTES/INSTRUCTIONS (CONT�D): Test procedure changes (Citation only)
ECO: 981782
A. Menu (brings up Setup Menu) with no video source. B. Adjust C711 on the Video board (the white variable capacitor) with a non-metallic screwdriver until the subcarrier display is stable (stops spinning) on a vectorscope. C. Select Options Setup. D. Set Video Fmt. to NTSC+ PAL. E. Press Menu to exit Options Setup. F. Select Program Setup and change the NTSC to PAL (bottom row on program 1 and re-adjust C711 on the Video board (the white variable capacitor) with a non-metallic screwdriver until the subcarrier display is stable on a vectorscope, monitor the main video output. G. When you switch between NTSC and PAL (by pressing the two program buttons 1=PAL and 2 =NTSC), you should see the vectorscope display lose lock (begin to spin). Re-adjust C711 until the display is stable for both NTSC and PAL. If you can not get the display to stablize for both, STOP HERE. Note the failure. The unit must be repaired. H. Get out of the Program Setup menu. Vector scope referenced above is the magni vector scope. ***Note that this section replaces the adjustment of C711 in preveous test procedures. The shunt jumper is not necasary for this adjustment.
|
|
|
> |
|
