|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The purchased manual is an high-quality scan of the original JVC paper-based Service Manual. The Service Manual includes the Owner´s Manual, so you do not have to buy both of them.
 ;
It paid to find this Service Manual, couldn't find it anywhere else. Exactly what I wanted. Received within 24 hours.
;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
;
Excellent printing quality. A complete and very useful manual with all details.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
In Your Print Job
Step 1 Define the Media Eject Length (the size of the paper in the custom paper tray, left to right) by sending the PCL code: Media Eject Length (see below). Step 2 Define the paper width (the size of the paper in the custom paper tray, front to back) by sending the PCL code: Select Custom Size (see below).
Media Eject Length
<ESC> & f # f/F
Sets the length of paper, as measured from the left edge to the right edge of the paper in the custom paper tray. Command arguments include: Value(#) Media eject length in decipoints (1/720 inch)
Default Device dependent (should be taken from User Default Environment) Range 0 to the maximum supported paper length (command is ignored for other values and the current paper length is retained) Use this command to define the size of your paper when using the custom paper tray, with the selection of <ESC>&l101A. The media eject length need not be the same as the physical page size defined by Page Size (<ESC>&l#A) or Page Length (<ESC>&l#P). If the media eject length is shorter than the physical page size, the physical page image will be clipped to fit the media eject size. If the media eject length is longer than the physical page size, the excess length will appear after the page image (to the bottom and right of the page image so the page image is placed at the upper left edge).
Page Width
<ESC> & f # g/G
Designates the width of the logical page for a given CMI. Command arguments include: Value(#) Default Logical page width in decipoints (1/720 inch) Device dependent
Range 0 to the maximum supported page width. For other values, the command is ignored and the current paper length is retained. If a value of 0 is received, page width is set using the following criteria (in order of priority):
4
Chapter 2: Printing Options
|
|
|
> |
|
