|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent had everything I wanted, very happy with purchase
 ;
This service is relatively cheap, document is fast available, schematic is readable.
Thanks.
;
So far I´m a satisfied customer. I have only downloaded "TECHNICS SX-KN470 Service Manual" maybe I will use it later.
Best regards
Peter
;
Good manual. It is complete and of high quality, both text and graphics. The schematics are with the original big size, so it can be viewed or printed without any loss of resulution and sharpness.
;
We needed a manual quickly...online it was available immediately, at a very low price. We loved the convenience!
Installation 1. Install the Y axis belt (item 3) onto the carriage assembly making sure the belt is in between the two slider rods (see figure 14, item 5). 2. Install the carriage assembly ' page 8 42 Note: Make sure the Y axis belt is not twisted. 3. Install the Y axis belt (item 3) around the Y axis belt pulley (item 6). 4. Install the Y axis belt pulley with the belt into the Y axis tensioner holder (item 2). 5. Install the belt around the Y axis motor pulley (item 5).
The spring is under high tension and could spring out of the Y axis tensioner holder.
Caution: Cup your hand over the Y axis tensioner holder in the next step to avoid losing the spring. 6. If you have removed the tensioner wedge clip (item 4) and the spring (item 1), install it now. To tension the belt, use a small flat blade screw driver to release the wedge tensioner clip from its position in the Y axis tensioner holder. 7. Install the following: 1. Left Hand Cover ' page 8 18. 2. Right Hand Cover ' page 8 21. 3. Window and Top Cover ' page 8 15. 8. Install the power cable.
WARNING
8-40
HP DesignJet CP Series Printers
Removal and Installation
|
|
|
> |
|
