|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
 ;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
IC301 Troubleshooting
Check the power supplying IC301 Pin 17, 54, 90? NO YES Check the 5V of IC301 pin 26 NO YES Check the oscillation of X301 NO YES When power supplying to IC301 pin11. (Low � High) NO YES Replace the IC301 Check the RESET circuit Replace the X301 Check the P-SENS Refer to �Power Circuit Troubleshooting�
IC400 Troubleshooting
Check the power supplying to IC400 pin24 NO YES Check the CLK Data of IC400 pin 21, 22 YES NO Check the PIN of MICOM 4, 5 Refer to �IC301 Troubleshooting� Check the pattern of MICOM (4, 5)- IC400 (21, 22) NO Refer to �Power Circuit Troubleshooting�
Check the waveform output of IC400 pin 8, 10 NO YES Check the waveform input of IC400 pin9, 11 YES Replace the IC400 Replace the IC400
Check the waveform output of IC400 pin26, 27
END - 2-9 -
|
|
|
> |
|
