HARMAN KARDON HK3475
Owner's Manual

OPERATION
Programming the Remote Buttons Step 1: Place the HK 3475 remote control and the remote control for the other device (e.g., compact disc player) so that their infrared transmitter windows face each other at a distance of about onehalf inch. Step 2: Simultaneously press the Learn Button � and the Source Selector ç that corresponds to the device whose codes you are trying to program (e.g., press the CD button along with the Learn button). The LED Indicator � will blink once and remain lit. Step 3: Press and release the button on the HK 3475 remote that you wish to program. Make sure that it is one of the programmable buttons listed in the table on page 17. The LED Indicator � will blink once and remain lit. Step 4: Press and hold the button on the other device�s remote whose code you wish to program into the HK 3475 remote until the LED Indicator � blinks three times and remains lit, then release the button on the other remote. If the LED Indicator � flickers for five seconds instead of blinking three times and remaining lit, the learning operation was unsuccessful. Try the procedure again, starting from Step 2, making sure that the transmitter windows of the two remotes face each other, and that the button you are trying to program on the HK 3475 remote is listed in the table on page 17. Step 5: To program additional buttons, repeat Steps 2 through 4. Step 6: To exit the learning mode, either press the Learn Button � once, or wait 20 seconds for the remote to automatically return to normal operation. Resetting One Key to Default Setting When a new code is programmed into the remote, it overwrites the previous code for that button on that page. However, should you make a mistake, it is possible to reset any button to its factory default using the following procedure: Step 1: Enter the learning mode by simultaneously pressing any of the Device Buttons ç and the Learn Button �. Step 2: Press and release the particular device button for the page containing the key you wish to reset. The LED Indicator � will blink once and remain on. Step 3: Use the Numeric Keys � to enter the numbers �777.� The LED Indicator � will blink for each entry. Step 4: Press and release the button that you wish to reset. The LED Indicator � will blink three times to indicate that the button has been reset to the factory default code. Step 5: You may repeat Step 4 to reset the codes for other keys. If you wish to reset the codes for an entire device page, see below. Step 6: To exit the learning mode, either press the Learn Button � once, or wait 20 seconds for the remote to automatically return to normal operation. Resetting an Entire Device Page If you wish to reset all of the codes for a particular device, you need not individually reset every button on that page of the remote. Step 1: Enter the learning mode by simultaneously pressing any of the Device Buttons ç and the Learn Button �. Step 2: Press and release the particular device button for the page you wish to reset. The LED Indicator � will blink once and remain on. Step 3: Use the Numeric Keys � to enter the numbers �888.� The LED Indicator � will blink for each entry. Step 4: The LED Indicator � will remain on for one second, and then blink three times to indicate that it has reset the group of keys for the selected device page. That device page will now operate the factory default set of codes. Resetting the Entire Remote It is also possible to completely reset all of the programmed codes in the remote to the factory default settings. Use the following procedure: Step 1: Enter the learning mode by simultaneously pressing any of the Device Buttons ç and the Learn Button �. Step 2: Press and release any device button other than PHONO, AM or FM. The LED Indicator � will blink once and remain on. Step 3: Use the Numeric Keys � to enter the numbers �999�. The LED Indicator � will blink for each entry. Step 4: The LED Indicator � will remain on for five seconds, and then blink three times to indicate that it has reset all of the keys on the remote. The entire remote will now operate the factory default set of codes.

18

OPERATION