|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Service Manual received was helpful. The electronic information is exactly what I needed.
;
The Manual was perfect.
The deliverie was perfect.
Thanks
;
Found website easy to use and manual very clear. First class service
 ;
The quality is quite good and clear. Nothing of the informations inside is lost during the digitalizing process
;
Very good service, fast downloads and good manuals.
HKTS 10/HKTS 12
OPERATION
Move the Master Power Switch � (marked Power) to the ��� (On) position. The subwoofer will automatically turn itself on or go into Standby mode, depending on whether or not a signal is being sent to it by your receiver or surround processor, and provided that the MusicSense On/Off Switch ¶ is moved to the right so that it is in the AUTO position. When your receiver or amplifier is off, or is not sending program material to the subwoofer, the subwoofer will be in Standby mode and the LED Indicator ª on the amp panel will turn red. When the subwoofer senses an audio signal, it will automatically turn itself on and the LED Indicator ª will turn green. If the subwoofer does not sense a signal after approximately twenty minutes, it will automatically go into Standby mode.
harman/kardon
When the Music-Sense On/Off Switch ¶ is switched to the ON position, the subwoofer will remain on, whether or not program material is playing. If you will be away from home for an extended period of time, or if the subwoofer will not be used, switch the Master Power Switch � to the OFF position.
Volume
Volume can be adjusted using the Subwoofer-Level Control �, as shown below.
Subwoofer Level
Subwoofer Level
MIN
MAX
MIN
MAX
Additional Bass Adjustments
In addition to the volume adjustments described above, the subwoofer includes a Phase Switch � and a Filter Switch § that can be used to adjust the bass response to suit your listening environment or taste. In most situations, the Phase Switch � should be left in the NORMAL position. If you suspect that the subwoofer is playing out of phase with the other speakers, which would tend to diminish bass response, try placing this switch in the REVERSE position. There is no harm in experimenting, and you may return the switch to the NORMAL position at any time. If you rearrange your room and reposition the speakers, it would be a good idea to check whether they are in phase by flipping this switch. The High-Cut (Low-Pass) Filter Switch § limits the frequencies of the audio signal inputted to the subwoofer to the low frequencies that the subwoofer reproduces best. This allows the subwoofer to perform more efficiently, and with superior bass reproduction, minimizing distortion that might occur if the subwoofer attempted to reproduce higher frequencies. This switch should be left in the ON position, except: 1. When the SUB Input £ is being used, in which case it has no effect, or 2. When the Speaker-Level Inputs � or the Line-Level Full-Range Inputs ¢ are being used with a crossover or filter on board the receiver or processor. In these two circumstances, place the switch in the OFF position.
8
|
|
|
> |
|
