|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Zeer duidelijke afdrukken op A4-formaat , zeer uitgebreide handleiding . Pluspunt ,zeer snelle
respons van jullie , binnen de 24h . Top !!!
;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
;
I was impressed with the quality of service (frequent e-mails to let you know the status of your order), and the speed at which the download became available. The manual was a life saver and was not easy to track down. Thank you for such an excellent service.
;
the manual was just what i wanted it had all the revelent information required to operate the hifi .Iwould use any manual i downloaded for any item which needs a manual
;
Die gewünschte Bedienungsanleitung wurde vereinbarungsgemäß in deutsch bereitgestellt. Sie ist gut lesbar. Kein Kauderwelsch.
Danke für den Service.
HP J06-59992A Time Interval Calibrator
Theory of Operation
B1
1-1
'
OUTPUT A In-phase OUTPUT B OUTPUT A In-phase/Swap P2 OUTPUT B OUTPUT A Out-of-phase OUTPUT B OUTPUT A Out-of-phase/Swap OUTPUT B
Figure 4-1. HP-1B Command Swnmary.
4-7. INPUT SIGNAL CONVERSION
INPUT
SPLITTER B2 Zero SPLITTER B3 INPUT
B4
180
P2
171
SPLITTER N2
eg
The zero degree power-splitter divides the input signal into two nearly inphase output signals, PI and P 2 Command "Bl" routes the input signal from P l to Output A and P2 to Output B;'732"routes the input from P1 to Output B and P2 to Output A Similarly, the 180-degree power-splitter divides the input into two nearly out-of -phase signals, N 1 and N2. Command "B3" routes the input signal from N 1 to Output A and N2 to Output 8; '%4" routes the input from N 1 to Output B and N2 to Output A Refer to Figure 4- 1 for a diagram illustrating the effect of the HP-IB commands. The commands "Bl -B4",(or switches 1-4 if manually operated), result in four binary states defined by the two bits arriving on A D 4 pin 4 and pin 6. The bit from pin 4, via buffers in A2U 1 energizes the appropriate relays A2K 1 and A2K2, routing the incoming signal from A2J1 to the desired powersplitter. The outputs of the selected splitter are fed to A2K3 where they are connected to Outputs A and B directly, or reversed through a cross-over K3 relay arrangement. Note that the input signal to the splitters and the output signals from the splitters are ac-coupled via blocking capacitors A2C 1, C8, and C9. Table 4- 1 summarizes the J06-59992A operation.
Page 4-2
www.hparchive.com
|
|
|
> |
|
