|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
Remove ribbon cable harness
Step 1 Remove the following assemblies: � Remove the toner cartridge. See �Toner cartridge removal and replacement� on page 100. � If installed, remove tray 3. See �Remove tray 3� on page 101. � Remove the cassette from tray 2. See �Remove the cassette from tray 2� on page 101. � Remove the DIMM cover. See �Remove DIMM cover� on page 103. � Remove the rear cover. See �Remove rear cover� on page 104. � Remove the top cover. See �Remove top cover� on page 106. Step 2 Unplug the two ribbon cables (callout 1). Step 3 Feed the cables through the opening towards the harness cover. Step 4 Lift the harness cover locking tab away from the printer chassis and slide the cover away from the duplexer reverse motor. Step 5 Lift off the harness and cover.
1
Figure 105. Note
Unplug the ribbon cables When installing the ribbon cable harness (callout 1), feed the cables through the opening in the chassis.
136 Chapter 6 Removal and replacement
C7058-90936
|
|
|
> |
|
