|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank you for your shop manual! Your help was very useful - the device is repaired! Once again - Thank you! I wish you a successful business! Edward (Russia).
;
It was a great experience,instead of purchasing a new Stereo Amplifier ,in just minutes i repaired my old one and that was thaks to the manual I have purchased from you.
Thanks again.
Samuel Alter
;
Das ging ja sehr unkompliziert hat bestens geklappt und die Quallität ist auch noch gut.
Vielen Dank dafür.
;
Everything okay, thanks a lot. It was a pleasure for me to make a deal with you.
;
A deal without problems, very fast and the manual is a good quality. Sorry for the my english.
Paper Quantity Switch Assembly
1 2 Remove the Back Cover from the 2000-sheet Input Tray (see figure 6-65 on page 238). Locate the cable that runs from the Paper Quantity Switch Assembly on the 2000-sheet Input Tray to the unit�s Controller PCA. Disconnect the cable from the Controller PCA (J205 connector), and then free the cable from the cable clips that secure it to the chassis (Figure 6-76, callout 1). Remove the 1 screw (callout 2) and the metal retaining spring (callout 3) that hold the switch assembly in place. Pull the switch assembly out of its cavity (Figure 6-77, callout 1).
3 4
To Reinstall:
1 When reinstalling the metal retaining spring that holds the switch assembly in place (Figure 6-76, callout 2), seat the retaining spring onto the locating pins that are on the chassis. Reconnect the switch assembly�s cable to the J205 connector on the Controller PCA (Figure 6-76, callout 1).
2
Paper Size Switch Assembly
1 2 Remove the Back Cover from the 2000-sheet Input Tray (see Figure 6-65). Locate the cable that runs from the Paper Size Switch Assembly on the 2000-sheet Input Tray to the unit�s Controller PCA. Disconnect the cable from the Controller PCA (J204 connector) (Figure 6-76, callout 4). Remove the 1 screw (callout 5) and the metal retaining spring (callout 6) that hold the switch assembly in place. Pull the switch assembly out of its cavity (Figure 6-77, callout 2).
3 4
To Reinstall:
1 When reinstalling the metal retaining spring that holds the switch assembly in place (Figure 6-76, callout 5), seat the retaining spring onto the locating pins on the chassis. Reconnect the switch assembly�s cable to the J204 connector on the Controller PCA (Figure 6-76, callout 4).
2
C4214-91000
2000-sheet Input Tray Removal and Replacement 257
|
|
|
> |
|
