|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great Manual. This manual is available no where else. It was exactly what I was looking for.
;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
 ;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
;
The service manual was complete and the components on the drawings very good visible.
Paper Sensor Lever Removal
(Figure 6-3, Reference 1) Follow steps 1 to 11 and steps 15 and 16 under �Disassembly,� then complete the following steps:
35 Grasp one of the four paper guides with the needlenose pliers and pull.
Repeat until all paper guides are removed. 36 Remove the spring. The paper sensor lever is held in place by one snap-in hinge on the left side of the back of the chassis.
37 Using the small flat-blade screwdriver, pry the paper sensor lever from
the hinge. 38 Slide the paper sensor lever to the left to remove.
Motor Removal
(Figure 6-3, Reference 9) Follow steps 1 to 11 and steps 15 to 24 under �Disassembly,� then complete the following steps:
39 Cup the motor with one hand (to prevent it from falling once the screws
are removed). 40 Remove the two screws on the motor with the Phillips-head screwdriver. 41 Remove the spring. The motor is now detached from the chassis.
Image Sensor Removal
(Figure 6-1, Reference 8) Follow steps 1-11 under �Disassembly,� then complete the following steps:
42 Grasp the image sensor on one side and pull it toward the opposite side
5
Maintenance
while at the same time using your thumb to press outward on the front cover tab. 43 Disconnect the connector wire to the image sensor.
EN
Removal and Replacement
5-5
|
|
|
> |
|
