|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
F. NOISE FILTER ASS'Y HIGH VOLTAGE DIODE, HIGH VOLTAGE CAPACITOR, AND COOLING FAN MOTOR REMOVAL
1 ) Disconnect lead wires from the noise filter ass'y and remove screw securing the noise filter earth wire to the back plate. 2) Push two hook of the guide suction and lift up the rear of noise filter ass'y. 3) Disconnect lead wires from H.V. capacitor and remove screw securing the H.V. diode earth wire to the back plate. 4) Disconnect each lead wires from the AC relay and the fan motor. 5) Remove two screws securing the guide suction ass'y to the back plate and lift up the guide suction ass'y. 6) Remove one screw from H.V. capacitor bracket. 7) Pull H.V. capacitor bracket from the guide suction. 8) Remove the fan from the fan motor. guide suction and lift it up. 9) Remove two screws securing the fan motor to the
H.V. Transformer
I. C-MOTOR, THERMISTOR AND SHEATH HEATER REMOVAL
1) Remove the two screws securing the cover assembly to the oven cavity. 2) Disconnect the leadwire from the circulation motor terminal and the sheath heater. 3) Remove the screws of the thermistor, guide assychamber and lift up the guide assy-chamber. 4) Remove a hex nut securing the circulation fan to shaft of the C-motor. 5) Remove screws securing the motor bracket to the guide assy-chamber. 6) Remove two hex nuts securing the C-motor to the motor bracket.
G. OVEN LAMP REMOVAL
1) Disconnect the wire leads from oven lamp. 2) Remove one screw securing the Air Duct to the magnetron. 3) Push hook to Right and Left of Air Duct, with Drive. 4) Lift the oven Lamp up.
H. HIGH VOLTAGE TRANSFORMER REMOVAL
1) Disconnect the wire leads from the transformer to the magnetron, C. Protector ASS'Y assembly. 2) Remove four screws securing the H.V. transformer to the base plate. 3) Lift the H.V. transformer up.
5-6
|
|
|
> |
|
