|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Replace the nozzles of the oven burners
Oven burner To replace the gas oven nozzle, follow this procedure: � Check the table no.1 for diameter of nozzle; � Remove the oven removable base panel; � Remove the screw "B" on the oven burner; � Remove the oven burner by pushing it backwards. � Replace the nozzle (C) by means of a No 10 socket spanner; Reassemble the parts following the same procedure in reverse. Grill burner To replace the gas grill nozzle, follow this procedure: � Remove the grill burner after removing the fixing screw. � Replace the nozzle by means of a No 10 socket spanner; � Refit all parts and test.
Flame adjustment
Oven burner The burner is correctly adjusted when the flame is stable, silent and goes out without any noise. � When the flames are too short, the nozzle is whistling or the flames have the tendency to detach from the burner, it means that there is too much air in the valve. If there is too much air there is a risk that the flames will extinguish. � But, if the flames are too long, soft, lighting, there is not enough air in the valves. These flames discolour the bottom of pans. � Loosen the fixing screw M, which fixing the air adjuster A; � Move the air adjuster A forward or backward until achieving the right mixture (see table no. 2); � Tighten the fixing screw M. Grill burner � Loosen the screw fixing the Venturi. � Move the adjusting collar left or right until achieving the correct flame picture (see table no. 2). � Tighten the fixing screw.
Table no.2 Gas type G20 G30 G31 Air adjusting (mm) Oven Grill 2,5 25,5 3,5 30 3,5 30
air adjusting
M A
opening
adjusting collar
screw
25
|
|
|
> |
|
