|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
SPIN TROUBLE
Check the S.PRESSURE SWITCH ASSEMBLY or HOSE (Pressure). If the problem is on the S.PRESSURE SWITCH ASSEMBLY or the HOSE, replace the S.PRESSURE SWITCH ASSEMBLY or the HOSE.
Check on the spinning, is the frequency of the water level 248 or more. The frequency can be
Rinse Spin
checked by pressing the Rinse and Spin buttons at the same time on the program.
NO
YES
When pressing Rinse, Spin and POWER buttons at the same time after power off, press the Start/Pause YES
Rinse Spin
Normal
button 2 times, is the drum spinning at low speed?
NO
(2) (1)
Is it disconnected, or disassembled? [Red:3pin (1), NA:4pin (2)]
YES
Correct the connector.
NO
Check the motor connector, Is the resistance of the terminal same as the figure?
NO
MOTOR TERMINAL (1)
(1)
Replace the STATOR ASSEMBLY (4417FA1994E)
Resistance of terminal: About 5 10
YES
Replace the MAIN PWB ASSEMBLY
29
|
|
|
> |
|
