|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
PULLEY, MOTOR, DAMPER
Remove the back cover. Take off the belt turning the pulley. Unscrew the bolt to pull out the pulley.
(PULLEY)
Unscrew 2 screws from the bracket. Push the motor in the arrow direction for disassembling. When reassembling the motor, make sure that motor
1 3
2
mounting bushings are not taken off from the bracket.
(MOTOR)
Hinge, Damper
Damper
Pull out the hinge, pressing its snap. Do not use the pulled out hinge again. It may be taken off during operation.
(DAMPER)
Clean the drain pump filter
3 1 2
3
2
Open the lower cover cap ( ) by using a finger Turn the drain plug ( to pull out the hose.
)
Unplug the drain plug ( ), then the water flows out, At this time use a vessel to prevent water flowing on the floor. If the water does not flow any more,turn the pump filter ( ) open to the left.
Take out any foreign material from the pump filter ( ). After cleaning, turn the pump filter( ) clockwise and insert the drain plug ( )to the original place. close the lower cover cap.
30
|
