|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
2 GETTING STARTED
2.1 Base station setup 2.1.1. Connect power cord to the AC power adaptor. 2.1.2. Plug the cord into the base station first and then plug the other end into a power outlet. 2.2 Load battery 2.2.1. Make sure the power switch at lower-left corner of your 100WT10P is in the OFF position. 2.2.2. Install the battery. 1. Place 100WT10P on your desk with its face down. 2. Place the battery in the battery slot then press it down to fit in. 3. Push battery latch 1 into the locked position. 4. For first time use, the battery requires five hours to become fully charged. 2.3 Stylus recalibration When the pad is powered on for the first time, the recalibration protocol will automatically launch. Follow the instructions to walk through the process. 2.4 WLAN setup 1.Tap START 2.Tap SETTINGS 3.Tap Network and Dial-up Connections 4.Tap 'Internal Wireless LAN' Settings icon 5. A dialog box pops up. Choose the Wireless Networks tab.Tap the Refresh button in the Available Networks panel. In a few seconds, a list of available networks is displayed 6. Select the network to which you wish to connect 7.Tap CONFIGURE 8.Tap OK
4
|
|
|
> |
|
