|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
8
M32 107T4 GS_3 Go to cover page
OSD Adjustments (Continued)
2) Press the button until ADJUST SHAPE is highlighted.
2) Press the
button until ADJUST VERTICAL is highlighted.
3) Press the button. The ADJUST VERTICAL window appears. ADJUST POSITION should be highlighted.
3) Press the button. The ADJUST SHAPE window appears. ADJUST SIDE CURVE should be highlighted.
4) Press the button. The SIDE CURVE window appears. PINCUSHION should be highlighted. 4) Press the or button to move the image up or down. button to return to MAIN
5) When the position is adjusted, press the CONTROLS window, or press the
button to highlight ADJUST SIZE.
5) To adjust the pincushion, press the BALANCED or press the window. 6) To adjust the vertical size, press the or button.
or
button. button to highlight
6) When the pincushion is adjusted, press the
button to return to the ADJUST SHAPE
7) When the size is adjusted, press the button to return to MAIN CONTROLS window. CLOSE MAIN CONTROLS will be highlighted. Smart Help After returning to MAIN CONTROLS . . . . . . to continue to ADJUST SHAPE, press the button until ADJUST SHAPE is highlighted. Next, start with step 3 under ADJUST SHAPE and follow the directions. . . . to exit completely, press the ADJUST SHAPE ADJUST SIDE CURVE ADJUST SIDE CURVE under ADJUST SHAPE allows you to adjust two of the five preset options. These two options are PINCUSHION and BALANCED pincushion. Note: use these features only when the picture is not square. 1) Press the appears. button on the monitor. The MAIN CONTROLS window button 7) To adjust the balanced pincushion, press the or button.
8) When the balanced pincushion is adjusted, press the button to return to the ADJUST SHAPE window. BACK TO MAIN WINDOWS will be highlighted. 9) Press the button to return to the MAIN CONTROLS window, or press the button until ADJUST SIDE ANGLES is highlighted.
|
|
|
> |
|
