|
Who's Online
There currently are 6011 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
AFC Adjustment: For TVs not including � L/L� � Standarts: � Switched the system to the desired standard, � Apply the IF signal to the IF inputs in accordance with the standards (38.9MHz for � B/G � and � D/K �, 39.5MHz for � I � ) at pin1 and 2 of SAW filter (Z101) � Adjust the VL101 until getting 2.5 Vdc at pin9 of the microcontroller (IC501). For TVs including � L/L� � Standarts: � Switched the system to a desired standard, � Apply the IF signal to the IF inputs in accordance with the standards (38.9MHz for � B/G � and � D/K �, 39.5MHz for � I � ) at pin1 and 2 of SAW filter (Z101), � Adjust the VL101 until getting 2.5 Vdc at pin9 of the microcontroller (IC501), � Switched the system to the standard � L �, � Apply the IF signal to the IF inputs in accordance with the standards (33.9MHz for � L �) at pin1 and 2 of SAW filter (Z101), � Adjust the VC101 until getting 2.5 Vdc at pin9 of the microcontroller (IC501).
10
|
|
|
> |
|