|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank you for providing this manual and at low cost.
The Philips scope is of excellent quality, longevity and build and had a couple of faults
when it was passed to me. Having the CCT diagrams is a blessing.
I have fixed the problems and also modded the scope to my requirements.
I have built a 24v Li-Ion pack for portable use from old but good laptop batts.
it is working beautifully and I am well pleased. Keep up the good work Guys.
 ;
manual was very helpful in learning how to propery use my washer. I could not find this manual anywhere else.
;
Awesome quality manual. You really saved my bacon with this one. Was looking for some specific information with regards to my "new" vintage VCR that didn't come with the owners manual. This site is truely a goldmine of available manuals. The quality of the scans are top notch.
Thank-you so much for this awesome manual. If you're looking for this Sony SL-HF400 owners manual, this is the one you NEED to buy. Definitely worth the money.
;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
ASSEMBLY
NOTE: Make sure unit is assembled correctly as shown in this manual. NOTE: Fit throttle wire in groove of lower harness clamp before tightening screws. S Insert two screws into the screw holes. S Secure harness clamp by tightening screws with a hex wrench. Adjusting the harness
S At the front of the harness is an easily accesible quick release. Use the quick release in any emergency situation that requires you to free yourself from the machine and harness.
Fitting the handlebar
S Remove the screw at the rear of the throttle handle. S Slide the throttle handle onto the right side of the handlebar (see illustration). S Align the screw hole in the throttle handle with the hole in the handlebar. S Refit the screw in the hole in the rear of the throttle handle. S Screw the screw through the handle and handlebar. Tighten the screw. S Fit the mounting components as shown.
Spreading the load on your shoulders
S A well-adjusted harness and machine makes work much easier. S Put on the harness. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders.
S The handlebar mounting must be fitted between the arrows on the shaft. S Tighten the screws with a hex wrench.
NOTE: It may be necessary to relocate
the harness clamp on the shaft for proper balancing of unit.
Fitting the harness
WARNING: When using a brushcutter, it must always be hooked securely to the harness. Otherwise, you will be unable to control the brushcutter safely. This can result in injury to yourself or others. Never use a harness with a defective quick release.
Proper harness and handlebar adjustments must be made with the engine completely stopped before using unit.
Fitting the harness clamp
S Place the upper harness clamp over the shaft and position the lower harness clamp under the shaft. Align the upper and lower clamp screw holes. Clamp must be fitted above the arrow on the shaft (see illustration). 10
|
|
|
> |
|
