|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
6. Manual recording
General information
Use 'Manual Recording' to make a spontaneous recording (for example, a programme currently being shown). If you want to start and stop a recording manually, read the section 'Recording without automatic switch-off'. If you want to start a recording manually but have it stopped automatically, read the section 'Recording with automatic switch-off'. (e.g. not to record to the end of the tape) Read the section 'Automatic recording from a satellite receiver', if you want a recording to be controlled automatically by a satellite receiver.
Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows: 1.Find the tape position of the old recording 1. where you want to insert the new recording. 2.Look at the last minute of the old recording 2. (playback). at the tape position where the new recording is to go and press REC I . 4.Now start recording as usual by pressing 4. REC I on the remote control. 5.Stop recording with STOP C-L . 5.
3.Press 3.
STILL 2
Recording without automatic switch-off
1.Insert a cassette. 1. 2.Use PROG P+ PROG P� or 2.
to select the programme number you want to record, for example, 'P01'.
REC I 0..9
Selecting the recording speed (SP or LP)
LP allows to double the recording duration on tape (for example six hours instead of three hours on a E180 cassette).
3.To start recording, press 3. 4.To stop recording, press 4.
. .
STOP C-L
1.Press 1.
MENU
. The main menu will appear.
PLAY B-K
Recording with automatic switch-off (OTR One-Touch-Recording)
1.Insert a cassette. 1. 2.Use 2.
PROG P+ PROG P� or 0..9 to select the programme number you want to record.
2.Select 'RECORD SETUP' with 2.
STOP C-L
and confirm with FWD 1- B . 3.Select the required recording speed with 3.
FWD 1- B
.
SELECT K L CHOOSE B �RECORD SPEED [SP]
3.Press REC I . 3. 4.Each time you press 4.
REC I you will add 30 minutes to the recording time. 5.To stop recording, press STOP C-L . 5.
END=EXIT
Preventing accidental erasing
All cassettes (except rental and pre-recorded cassettes) have a security tab on the back of the cassette. To prevent recording over important recordings (erasing), you can remove this security tab. If you later decide to record on a protected cassette, simply cover the hole with adhesive tape or slide the tab to the right.
4.To end, press 4.
STATUS/EXIT
.
'SP'/'LP' 'SP': StandardPlay (normal recording speed) offers the usual first-class picture quality. 'LP': LongPlay (half recording speed, double recording time). 6 hours can be recorded on a 3hour cassette (E180) with a somewhat reduced picture quality.
11
EN
|
|
|
> |
|
