|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
1.
CONNECT THE TV-VIDEO COMBI
Placing the batteries in the remote control
a Open up the battery compartment of your remote control
Important for the United Kingdom
This apparatus is fitted with an approved moulded 13 Amp plug. To change a fuse in this type of plug proceed as follows:
a Remove fuse cover and fuse. b Fix new fuse which should be a BS1362 5A, A.S.T.A. or
and place the batteries in it as shown in the picture.
BSI approved type.
c Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A. D Note: * The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere. How to connect a plug: The wires in the mains lead are coloured in accordance with the following code: BLUE - �NEUTRAL� (�N�) BROWN - �LIVE� (�L�)
d The BLUE wire must be connected to the terminal which
b Close the battery compartment.
is marked with the letter �N� or coloured BLACK.
e The BROWN wire must be connected to the terminal
which is marked with the letter �L� or coloured RED.
f Do not connect either wires to the earth terminal in the
plug which is marked with the letter �E� or by the safety earth symbol \or coloured green or green-and-yellow. Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not imply over the two wires.
4
|
|
|
> |
|
