|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am a vintage hifi collector. No way to fix that device without the appropriate service manual...thanks to your site I got it and every thing is easier now. I got the manual right after ordering: fast cheap accurate ... thank you
;
Wonderful job clear. Qick fantastic. These people are really good. If even a problem arise they are wonderful assisting you. These scheme is so net despite this is a very old TV. Thank you for everything!!!!!!!!
;
Detailed schematic diagram, manual for professionals
;
Good service manual,exploded view,adjusment and test point locations,head alignment,mechanical checks and adjusments,all perfect.
;
Block diagram,play rec block diagram,adjusments, it's a very good well done repair manual.
14VT-N10T(S)
INSTALLING THE MASTER CAM (AT REAR SIDE OF MECHANISM CHASSIS)
1. Make sure beforehand that the shifter is at the point as shown below. 2. Place the master cam in the position as shown below.
E-ring (XRESJ30-06000) Master cam
REPLACEMENT OF LOADING MOTOR
� Removal
Apply grease Apply grease
Fully turn clockwise
No grease Fully turn counterclockwise Face the wide tooth side ward
Figure 1-44-1. Note: See the figure below for the phase matching between the master cam and the casecon drive gear. 3. Finally fix with the E-ring. � Replacement 1. Remove the loading motor, and install the replacement loading motor as shown below.
Figure 1-45.
Master cam
Casecon drive gear 10.2 +0.2 mm
�0.2
Half-round notch Round mark
When installing the master cam, align the casecon drive gear round mark with the half-round notch of master cam.
Figure 1-46.
Figure 1-44-2.
The loading motor pressing-in must be less than 14.7 N (15 gf). Adjust the distance between motor and pulley to 10.2 +0.2 mm).
�0.2
36
|
|
|
> |
|
