|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This site is working fine! Did buy a manual for SX-EX25L and after a while I could download it and fix the problem. Nice and easy!
 ;
Complete manual as pdf-file in very good quality. Very helpful and fast availability.
;
Complete service manual in very good scanning quality with all schematic and PWB graphics as well as assembly & maintenance instructions. A slight drawback is that the rastering of the PWB graphics sometimes makes it a bit difficult to follow fine traces, but no showstopper.
;
Purchased the manual that I was looking for at a great price and could download it easily.. Great service experience and for future purchases I plan to use the site. Thank you very much
;
Service manual in good quality, it was very helpful to me. Perfect service, I am very satisfied.
Jochen Kelm
3. Turn the LCD (2) on its back and remove two screws (4). 4. Slide the back lights (5) on the top and bottom out to the left side and remove the LCD (2).
Screws (4)
3. Remove the connectors (4) from the four locations and remove the wire from the three locations of claw B.
Connector (4) Inverter PC board holder (2)
Claw B
Rear side of the LCD panel (2)
Wire
Claw B
Back light (5)
Connector (4)
Fig. 1-1-7 Fig. 1-1-5 4. Release four claws C, then remove the inverter PC board holder (2) from the inverter PC board (5). 5. Remove the connector (6) from the one location, then remove the inverter PC board (5).
Note: � Return the wiring to their original position when assembling.
1-3. Inverter PC Board
1. Remove the wire of connector (1) from the inverter PC board holder (2) claw A. 2. Remove two screws (3).
Wire Screws (3)
Inverter PC board (5) Connector (6)
Claw C
Claw C Claw C
Claw A
Inverter PC board holder (2)
Claw C
Inverter PC board holder (2)
Fig. 1-1-8 Note:
Connector (1)
� Return the wiring to their original position when assembling. � The inverter PC board contains high voltage circuitry and therefore the power supply plug should always be unplugged during disassembly and assembly.
Fig. 1-1-6
1-2
Additionally, care should be taken when servicing while the power is on.
|
|
|
> |
|
