|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
THE MACKIE FIXER � MACKIE DESIGNS SERVICE NEWS
To make Aux 3/5 and Aux4/6 Pre-EQ and Pre-Fader Aux 3/5 1. Cut the trace between the round and square pads at point D on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at D to the square pad at F on the same channel. 3. Repeat for other channels as required. Aux 4/6 1. Cut the trace between the round and square pads at point E on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at E to the square pad at F on the same channel. 3. Repeat for any other channels as required. To make Aux 3/5 and Aux4/6 Post-EQ and Pre-Fader Aux 3/5 1. Cut the trace between the round and square pads at point D on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at D to the square pad at B on the same channel. 3. Repeat for other channels as required. Aux 4/6 1. Cut the trace between the round and square pads at point E on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at E to the square pad at B on the same channel. 3. Repeat for any other channels as required.
bottom of main board
Area of interest for one channel. (Move along the board sideways to do the other channels)
1604-VLZ Aux mod, sheet 2 of 3
|
|
|
> |
|
