PHILIPS 19PS40C
Owner's Manual

HOOKING UP YOUR TV (BASIC ANTENNA TV CONNECTIONS)

A

combination antenna receives normal broadcast channels (VHF 2-13 and UHF 14-69). Your connection is easy since there is only one 75� (ohm) antenna plug on the back of your TV - and that�s where the antenna goes.
If your antenna has a round cable (75 ohm) on the end, then you're ready to connect it to the TV. If your antenna has flat twin-lead wire (300 ohm), you first need to attach the antenna wires to the screws on a 300 to 75 ohm adapter.

Note: For homes with separate UHF and VHF antennas you will need an optional combiner to connect to the TV.
U/V Combiner

Back of TV

75-300 Ohm Adapter

Push the round end of the adapter (or antenna) onto the 75� plug on the rear of the TV. If the round end of the antenna wire is threaded, screw it down finger tight.

SMART HELP
Remember: Be sure to set the TV for the type signal you've connected (see the �Tuner Mode� section on page 11 of this manual.) To set the TV to select only the channel numbers in your area see how to �Program" or "Add" channels in the TV�s memory on page 12 (Auto Program section). To order any optional accessory contact your dealer or the Philips Parts Center at 1-800-851-8885.
75

2 1
300 to 75� Adapter

75
Back of TV

Combination VHF/UHF Antenna (Outdoor or Indoor)

Twin Lead Wire
OR

Round Cable 75�

6