|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A good manual! fast service and good qualityi for pdf document.
thanks!
 ;
Very helpful and complete manual. Maybe only one negative is schematics have sometimes unreadable name of the parts. But it's not a big problem.
;
Excellent high quality schematics brought my old Heidelberg back to life. Fast download at a reasonable price. Thanks.
;
This document is just what I was looking for, it´s very useful, it contains adjustment procedures for the final stage of the power amp and also
has a complete wiring diagram and description of the main semiconductors used in the design.
;
Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
Go to cover page
17
General Troubleshooting Guide (Continued)
Resolution can not be changed and LightFrame not work on Mac PC
Resolution can not be changed and LightFrame not work on Power Mac
YES 1. Test monitor with different IBM pc NO 1.1. Consulted by system/video chipmakers for the right version of video chip drive
YES 2. Right video card/ driver,but resolution still not changeable NO 2.1 Consulted by system/video chip makers for the right version of video chip driver
YES 3. Right monitor type for your Mac system NO 3.1 Consulted by system makers for the desired resolution
YES 4. Proper VGA Adaptor for your Mac NO 4.1 Consulted by system makers for the proper VGA Adaptor and where to buy
4.1. VGA Adaptor is the interface between
Mac and normal IBM VGA monitor, see the figure.(It's one kind of sample only) 4.2. Resolution changed on Mac is done by setting of DIP switch of the adaptor (change ID configuration) 4.3. Power Mac G4 has been implemented the VGA feature on Mac system(3 rows,15 pins D-shell connector) 5.1. Only power Mac G4 can run LightFrame or other Mac which system output with VGA 15 pins(3 rows) D-shell connector 5.2. The LightFrame not work on Mac due to Mac dis-connect DDC output for IBM VGA Monitor(pin 12 for SDA and pin 15 for SCL) 5.3. Sub-content:pcstuff.
6.1. Please be noticed that LCD monitor can not run the LightFrame
YES 5. LightFrame still not possible to install for Mac NO 5.1 LightFrame can not run on mac except Power Mac G4
6.
VGA adaptor for Mac PC (one kind of sample)
Back
Forward
|
|
|
> |
|
