This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
Text excerpt from page 17 (click to view)
Wall unit mounting - Fig. 6
� Position the template (1) on the wall and mark the position, and drill (2) the holes (2 x � 8 mm). � Mount the two rawl plugs with the hooks (3). � Hang the hood on the hooks and level it with the adjustment screws (4). � Remove the grease filters (5) and mark for the two screws (6). Remove the hood and drill the holes (2 x � 8 mm). � Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it horizontally with the screws (8) and secure it with the screws (9). � Mount the chimney holder (10) with the rawl plugs (9) and the screws (11). Be careful that it is centered over the hood and horizontally aligned. � Fitting for extractor version (S): Connect a tube between the hood air outlet and the wall or roof exhaust channel. Note that the top part of the chimney can be mounted with the side grids up or down. For use as an extractor version hood it must be mounted with the grids downwards. Fitting for filter version (K): Mount the deflector (12) with the two screws (13) supplied. � Make electrical connection (14) (see paragraph �Electrical connection�) � Place the chimney (15) and fix it to the top chimney holder with the two screws (16) supplied. Lower the bottom part of the chimney and fasten it to the top of the hood with two screws (17), supplied. Note that the top part of the chimney can be mounted with the side grids up or down. For use as a recirculation hood it must be mounted with the grids upwards.
