|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
;
Excellent quality, very quick download turnaround, will definately use again.
 ;
This is a awesome quality scan of the original Service Manual for Technics 8099.
Contains the circuit diagram, PCB layout, adjust/tune instructions as well.
Since this is my first buy here, i'm really glad! This site do works as intended/described, it's definitely not scam!
Мои рекомендации! Все мануалы настоящие!
2. SCREEN
1) Receive the Retma pattern and heat run over 15 minutes. 2) Adjust the �R, G BIAS, R, G DRIVE� to 0, �B BIAS� to 127, �B DRIVE� to 32. Adjust the screen volume that the Retma pattern reach to the cut-off point.
3. WHITE BALANCE
1) Receive the Full white pattern and heat run over 15 minutes. 2) Adjust the picture control at the point �Y� value of white balance instrument in 20cd/. 3) Enter the service mode. 4) Adjust �R BIAS, G BIAS� to x=288, y=301. 5) In order to exit the service mode power off the TV set and power on. 6) Set the TV set to �Normal I� mode(20/21 inch) or set to �Normal II� mode(14 inch) 7) Enter the service mode. 8) Adjust �R DRIVE, G DRIVE� to x=288, y=301. 9) Repeat above process until the white balance value to x=288, y=301, Y=20, x=288, y=301, Y=200(approximate) in 2) � 8).
4. FOCUS
1) Apply a RETMA PATTERN signal. 2) Adjust the Focus Volume on FBT to obtain optimal resolution.
5. AGC
1) Set the pattern Generator with RF LEVEL = 60dBuV 100% FULL COLOR BAR 2) Connect the pattern generator RF output to tuner RF input. 3) Connect the probe of oscilloscope in AGC pin of tuner. 4) Adjust the AGC point to MAX � 1V. (Simple Method) 1) Receive the pattern. 2) Locate the cursor in �AGC� and adjust using the �VOL +� or �VOL �� keys. 3) Adjust the point there is no noise in about 60dBuV and no beat in about 90dBuV.
|
|
|
> |
|
